Texas opens SH 130 and SH 45 SE to permitted oversize loads in a pilot that starts Nov. 12

TxDOT's test lets eligible OS/OW permit holders bypass I-35 construction east of Austin, with size limits, set entry points and tolls paid by the carrier.

Car driving on a wide, straight divided highway under a blue sky, with a speed limit sign on the right shoulder
Photo: formulanone, Wikimedia Commons · CC BY-SA 2.0

Starting Thursday, Nov. 12, some oversize and overweight loads in Central Texas can take the SH 130 and SH 45 Southeast toll roads instead of I-35.

The Texas Department of Transportation says the pilot is meant to move permitted trucks off I-35, where expansion work around Austin continues to slow traffic. TxDOT says it will review the program after six months and then decide whether to extend or change it.

Size and weight limits

According to the Texas Department of Motor Vehicles, vehicles and loads on the pilot route cannot exceed:

  • 16 feet wide
  • 16 feet high
  • 254,300 pounds gross, or 200,000 pounds when axle spacing is less than 95 feet

TxDOT adds that superheavy loads are not allowed.

How to get on the route

Carriers ask for access in the Notes field of the Texas Permitting & Routing Optimization System (TxPROS) when they apply for the permit. TxDMV's Motor Carrier Division reviews each request and, when appropriate, routes the load onto SH 130, SH 45 SE or both.

Access is limited. On SH 130 Segments 1 to 4 and SH 45 SE, permitted trucks may use only the main lanes. They may not use the ramps or direct connectors to SH 45 North, U.S. 290 or SH 71. TxDOT lists these approved entry and exit points:

  • I-35 in Georgetown
  • U.S. 183 at Buda/Mustang Ridge: southbound Exit 457, northbound Exit 460
  • SH 21: southbound Exit 461, northbound Exit 463
  • Lockhart/U.S. 183 connection: Exit 470 in both directions
  • SH 142: southbound Exit 471, northbound Exit 474
  • SH 80: Exit 482 in both directions
  • SH 45 SE connections to and from SH 130, including Exit 458
  • I-10 at Exit 614

Permitted trucks are not allowed on any other Austin-area toll road run by TxDOT or the Central Texas Regional Mobility Authority.

Curfew

In the Austin area, loads up to 12 feet wide and/or 95 feet long may not travel from 7 to 9 a.m. or from 4 to 6 p.m., Monday through Friday.

Tolls

The carrier pays all tolls. On SH 130 Segments 1 to 4, oversize and overweight vehicles pay the same rates as other trucks. On Segments 5 and 6, run by SH 130 Concession Company, permitted loads are billed as Class F, at a higher rate than standard commercial trucks.

A toll tag isn't required, but TxDOT recommends one because tag rates are lower than pay-by-mail rates. Accepted tags include TxTag, EZ TAG, NTTA TollTag, K-TAG, SunPass, ExpressToll, PikePass and Fuego Tag. Law enforcement will watch pilot traffic for compliance with permit terms, TxDOT says.

Up next

Diesel slips under $6 a gallon in AAA's national average, about 53 cents below its September record

AAA put the average at $5.999 on Monday, down 17 cents in a week and 33 cents in a month. It is still about $2.23 higher than a year ago.

House bill would make DHS's CDL fraud tipline permanent and require yearly state-by-state counts

Rep. Dave Taylor's CDL Fraud Tipline Act, H.R. 11031, has 10 Republican cosponsors and the backing of American Truckers United. It now sits with the House Transportation and Infrastructure Committee.

Wolf Creek Pass is open for the weekend, but US 160 closes again at 6 a.m. Monday for a week of paving

CDOT plans to reopen the flood-damaged pass for good before Thanksgiving. Until Monday, expect one-lane work zones, signals, delays of up to 20 minutes and snow.

We use Google Analytics to count visits. This site runs no advertising. You can decline anytime. Read more